中文版The signal line
The cable direction should be horizontal and vertical, and the cold pressing head (also known as the pin) must be pressed on both ends;
When turning the cable, avoid dead bending and it is best to be smooth. This avoids damage to the outer skin and internal copper core of the cable.
The wiring of the equipment on the front door panel is all connected with flexible wires to prevent wire breakage;
Wrap the wires that are not in the slot with wrapping pipes to ensure that only the markings and joint parts can be seen from the outside;
Signal and cable lines should be avoided from overlapping as much as possible to avoid interference.
Short wiring
The length of short wires with equal spacing should be consistent, preferably connected by a single wire;
The height and isolation of the same short circuit should be consistent;
If there is only one short wire on the wiring terminal, press on the cold pressed terminal;
power cord
When the positive pole of the power supply is marked with "+" on the DC output and module of the power supply, a red cable is used. When the positive pole is marked with "-" or "GND", a black cable is used, and other colored cables, such as blue or yellow, are used for the signal wire.
For AC power wiring, red or brown wire is used for "L", blue or black wire is used for "N", and yellow or green or chartreuse wire is used for "G".
